Method for the evaluation of the materials machinability by electrical discharge machining
by Laurentiu Slatineanu, Margareta Coteata, Oana Dodun, Dan Adrian Anton
International Journal of Machining and Machinability of Materials (IJMMM), Vol. 5, No. 2/3, 2009

Abstract: One of the ways to evaluate the material's machinability by electrical discharge machining is based on the quantity of material removed from the test piece through a single electrical discharge. Relatively simple equipment able to allow the evaluation of machinability on the basis of the above-mentioned principle has been built and used for experiments.

Online publication date: Fri, 20-Feb-2009

The full text of this article is only available to individual subscribers or to users at subscribing institutions.

 
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.

Pay per view:
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.

Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Machining and Machinability of Materials (IJMMM):
Login with your Inderscience username and password:

Username:        Password:          Forgotten your password?

Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.

If you still need assistance, please email subs@inderscience.com