The influence of deep cryogenic treatment and in-situ cryogenic micro turning of Ti-6Al-4V on cutting forces, surface integrity and chip morphology Online publication date: Fri, 19-Jul-2019
by T. Jagadesh; G.L. Samuel
International Journal of Precision Technology (IJPTECH), Vol. 8, No. 2/3/4, 2019
Abstract: The demand for sustainable manufacturing of axi-symmetric, micro turned titanium based neurosurgical implants are increasing. However, dry micro-turning of titanium alloy at higher cutting speeds, results in poor surface integrity, because of continuous saw-tooth chip formation, chip adhesion, and micro-scratch initiation on the machined surface. To overcome these issues in micro-turning, two techniques were attempted in this paper. First, Ti-6Al-4V is cryogenically cooled for 72 hours and then subsequently heat treated for four hours at 170°C before machining. Second, in-situ cryogenic experiments, liquid nitrogen is fed in the cutting zone. It is observed that, in-situ cryogenic micro-turning assists in ease of chip fracture resulting in good surface finish. It inhibits the formation of saw-tooth chip and thereby a fluctuation of forces with time is limited. Micro-scratch and adhesion of machined chips were present in non-treated and deep-cryogenic treated surfaces whereas, in-situ cryogenically micro-turned surfaces were free from the above defects.
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Precision Technology (IJPTECH):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email subs@inderscience.com