Some investigations into wire electro-discharge machining performance of Al/SiCp composites Online publication date: Tue, 06-Feb-2007
by N.G. Patil, P.K. Brahmankar
International Journal of Machining and Machinability of Materials (IJMMM), Vol. 1, No. 4, 2006
Abstract: Non-traditional process like Wire Electro-Discharge Machining (WEDM) is found to show a promise for machining Metal Matrix Composites (MMCs). In the present study, the effect of various control parameters such as pulse on-time, off-time, ignition pulse current, wire speed, wire tension and flushing pressure on cutting speed and surface finish in WEDM of Al/SiCp has been investigated by using Taguchi methods. Mathematical models relating the machining performance and machining parameters have been formulated. Optimal settings for each performance measure have also been obtained. A comparative study on unreinforced alloy revealed the effect of reinforcement on the machining process. It was found that the cutting speed for unreinforced alloy was higher compared to MMC. But surface finish in MMCs was superior compared to the unreinforced alloy. Wire breakage was found to pose limitations on the cutting speed of MMC.
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Machining and Machinability of Materials (IJMMM):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email subs@inderscience.com
Our Blog 
Follow us on Twitter 
Visit us on Facebook