Ductile fracture mechanics and chip separation in cutting Online publication date: Fri, 19-Oct-2007
by Pedro A.R. Rosa, Paulo A.F. Martins, A.G. Atkins
International Journal of Machining and Machinability of Materials (IJMMM), Vol. 2, No. 3/4, 2007
Abstract: The role of surface work in modelling metalworking processes in which separation takes place (machining, blanking, etc.) is discussed. Traditional algebraic and finite element analyses of such processes, incorporating only plastic flow and friction, are able to predict quite well the experimentally-observed material flow fields. However they always underestimate the experimental forces when independently-determined mechanical properties (flow stress, toughness and friction at the correct rates and temperatures) are employed. The deficiency in predicting the forces is directly connected to omitting work of surface formation in the analyses. A new experimental test piece is described for the independent determination of the specific work of separation. Values so obtained serve both as a check on the reasonableness of ductile fracture toughness determined from cutting tests and also for calibration of Finite Element Method (FEM) simulations of such processes.
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Machining and Machinability of Materials (IJMMM):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email subs@inderscience.com