Accompanying phenomena in the cutting zone machinability during turning of stainless steels
by Jozef Jurko, Anton Panda, Mario Gajdos
International Journal of Machining and Machinability of Materials (IJMMM), Vol. 5, No. 4, 2009

Abstract: The rapid development of industry is marked by the development and application of new materials with characteristics that broaden their applicable uses. Therefore, it is natural that advances in machinability attract a considerable interest even today. Precise and reliable information on the machinability of a material before it enters the machining process is a necessity and hypotheses must be tested through verification of actual methods. This article presents conclusions of machinability tests on austenitic stainless steels 1.4301 and describes appropriate parameters for the cutting zone during the process of turning. The article focuses on the analysis of selected domains through four basic some parameters of steel machinability.

Online publication date: Sun, 28-Jun-2009

The full text of this article is only available to individual subscribers or to users at subscribing institutions.

 
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.

Pay per view:
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.

Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Machining and Machinability of Materials (IJMMM):
Login with your Inderscience username and password:

Username:        Password:          Forgotten your password?

Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.

If you still need assistance, please email subs@inderscience.com