Basic principles of low-pressure injection moulding and experience with the process
by Rainer Sack, Klaus-Dieter Lietzmann
International Journal of Materials and Product Technology (IJMPT), Vol. 8, No. 2/3/4, 1993

Abstract: The process of low-pressure injection moulding being normally used to make ceramic parts was modified for the manufacture of metal samples. Using the binder systems typical of injection moulding (paraffin and wax), experimental studies were carried out with commercially available carbonyl-iron powder in the grain size range

Online publication date: Thu, 04-Nov-2010

The full text of this article is only available to individual subscribers or to users at subscribing institutions.

 
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.

Pay per view:
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.

Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Materials and Product Technology (IJMPT):
Login with your Inderscience username and password:

Username:        Password:          Forgotten your password?

Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.

If you still need assistance, please email subs@inderscience.com