Characterisation of surface martensite-austenite transformation during finish turning of an AISI S15500 stainless steel Online publication date: Tue, 13-May-2014
by Alexandre Mondelin; Joël Rech; Eric Feulvarch; Michel Coret
International Journal of Machining and Machinability of Materials (IJMMM), Vol. 15, No. 1/2, 2014
Abstract: During machining, extreme temperature conditions appear in the cutting zone (from 700 to 1,000°C with heating rates around 106 °C/s). Consequently, the metallurgical models used to simulate the impact of the manufacturing process must be adapted to this fast thermal kinetics. Stress-free dilatometry tests have been performed to determine the austenisation kinetics of an AISI S15500 martensitic stainless steel and to identify a phenomenological model. Experimental heating rates vary from 6 °C/s to 11,000 °C/s. The metallurgical model calibrated for high heating rates, has been applied to a typical machining thermal cycle. It has been shown that martensite→austenite transformation does not have the time to significantly occur during the finish turning of AISI S15500 under standard cutting conditions. This result has been confirmed using retained austenite measurements in the machined surface layer.
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Machining and Machinability of Materials (IJMMM):
Login with your Inderscience username and password:
Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.
If you still need assistance, please email subs@inderscience.com